The component purchased
was compared with the one used in the simulation as to make sure the correct
component with correct value are bought.
All the components were
then grouped by their use and purpose for each particular circuit to be
constructed. This made the circuit construction a lot easier as there will be
no confusion in picking component while constructing the circuit on breadboard.
The circuit
construction was first begun with the voltage comparator, followed by AC-DC
converters, then charging circuits and at last with voltage balancer circuits.
Each single circuit constructed was tested individually for their
functionality.
At that time, since only one
breadboard was available, so I tried to construct the circuits as compact as
possible to fit all of it on that single breadboard available. The complete
circuit on the breadboard was shown in figure below, from left is voltage comparator
circuit, voltage balancer circuit, charging circuit, and rectifier circuit.
Figure showing complete circuit
constructed on breadboard.
No comments:
Post a Comment